Kit Assembly
The following photos and text are not the same as the full kit manual but it should serve as an introduction to the insides of the TX102 ptreamp kit. For the full series of kit documents please go to our Download page.
Back Plate
The Kit case was designed so that the front and back plates can be removed for easy assembly. This is the Back Plate Assembly showing the plate pre-wiring.
Back Plate - close up view
This is a close up view of the center section of the Back Plate.
Back Plate - close up view of one side
This is a close up view of one side of the Back Plate.
Front Plate
This pic shows the front plate with the Seiden switches installed and the source selectors pre-wired.
Front Plate and Base Plate
Next the view of the Front Plate and Base Plate with TX102 wiring begun for the Right Channel.
TX102 Clamp
This pic shows a close up view of the clamp assembly that the TX102 fits into.
Right Channel TX102
Here is a view of the Right Channel TX102 to Seiden switch wiring.
Both TX102 Units
Here is a pic after the left channel TX102 has been installed.
Source Selector
This pic shows the TX102 primary wires connected to the Seiden source selector swirch.
Front and Back Plates
Now the back plate is in position and ready to wire up the input connectors to the input selecttor switches.
Inside View
This shot shows the back plate to front plate wiring after the Back Plate is attached in place.
Finished Wiring - View 1
Here is a view into the finished unit.
Finished Wiring - View 2
Here is a different view into the case.
Click Here To Go To Our Downloads Page To Download Schematics, Drawings, and Documents